732 CHAPTER 66: P O E P ROFILE CONFIGURATIONn The following rules should be obeyed■ A PoE profile is a group of PoE configurations. Multiple PoE features can be setin a PoE profile. When the apply poe-profile command applies a PoE profileto a port, some PoE features can be applied successfully while some PoEconfigurations in it cannot.■ When the apply poe-profile command is used to apply a PoE profile to aport, the PoE profile is applied successfully if one PoE feature in the PoE profileis applied properly.■ If one or more features in the PoE profile are not applied properly on a port,the switch prompts explicitly which PoE features in the PoE profile are notapplied properly on which ports.■ The display current-configuration command can be used to query whichPoE profiles are applied to a port. However, the command cannot be used toquery which PoE features in a PoE profiles are applied successfully.Displaying PoE ProfileConfigurationAfter the above configuration, execute the display command in any view to seethe running status of the PoE profile. You can verify the configurations by viewingthe information.PoE ProfileConfigurationExampleNetwork requirementsEthernet2/0/1 through Ethernet2/0/10 of the Switch 7757 are used by users ofgroup A, who have the following requirements:■ The PoE function can be enabled on all ports.■ Signal cables are used to supply power.ApplytheexistingPoEprofileto thespecifiedEthernet portSystem view apply poe-profileprofile-nameinterfaceinterface-typeinterface-number[ to interface-typeinterface-number ]RequiredUsers can decidewhether to configurethe settings in systemview or port viewIn Ethernet portview:Enter Ethernet portviewinterfaceinterface-typeinterface-numberApply the existingPoE profile to theportapply poe-profileprofile-nameTable 589 Configure PoE profileOperation Command DescriptionTable 590 Display the PoE profile configurationConfiguration Command DescriptionDisplay the detailedinformation about the PoEprofiles created on the switchdisplaypoe-profile { all-profile |interface interface-typeinterface-number | nameprofile-name }The display command can beexecuted in any view
