1-5Note that:z The remote-ping server function is needed only for jitter, TCP, and UDP tests.z You can configure multiple TCP/UDP listening services on one remote-ping server, with eachlistening service corresponding to a specific destination IP address and port number.Remote-ping Client ConfigurationRemote-ping client configurationAfter remote-ping client is enabled, you can create multiple test groups for different tests, without theneed to enable remote-ping client repeatedly for each test group.Different types of remote-ping tests are somewhat different in parameters and parameter ranges. Thefollowing text describes the configuration on remote-ping client for different test types.1) Configuring ICMP test on remote-ping clientFollow these steps to configure ICMP test on remote-ping client:To do… Use the command… RemarksEnter system view system-view —Enable the remote-ping clientfunction remote-ping-agent enableRequiredBy default, the remote-pingclient function is disabled.Create a remote-ping testgroup and enter its viewremote-pingadministrator-nameoperation-tagRequiredBy default, no test group isconfigured.Configure the destination IPaddress destination-ip ip-addressRequiredBy default, no destinationaddress is configured.Configure the source IPaddress source-ip ip-addressOptionalBy default, no source IPaddress is configured.Configure the test type test-type icmpOptionalBy default, the test type isICMP.Configure the number ofprobes per test count timesOptionalBy default, each test makesone probe.Configure the packet size datasize sizeOptionalBy default, the packet size is 56bytes.Configure a stuffing characterstring datafill stringOptionalBy default, the numbersbetween 0 and 255 are stuffedinto datagrams in a cyclicallyway.Configure a test description description stringOptionalBy default, no descriptioninformation is configured.
