1-9After you allow a port to output the Up/Down log information, if the physical link status of the port doesnot change, the switch does not send log information to the log server but monitors the port in real time.Disable Up/Down log output on a portTable 1-10 Disable UP/Down log output on a portOperation Command RemarksEnter system view system-view —Enter Ethernet port view interface interface-typeinterface-number —Disable a port from outputtingUP/Down Log Information undo enable log updownRequiredBy default, UP/Down loginformation output is enabled.Configuration example# By default, a port is allowed to output the Up/Down log information. Execute the shutdown commandor the undo shutdown command on Ethernet 1/0/1, and the system outputs Up/Down log informationof Ethernet 1/0/1. system-viewSystem View: return to User View with Ctrl+Z.[Sysname] interface Ethernet 1/0/1[Sysname-Ethernet1/0/1] shutdown%Apr 5 07:25:37:634 2000 Sysname L2INF/5/PORT LINK STATUS CHANGE:- 1 -Ethernet1/0/1 is DOWN[Sysname-Ethernet1/0/1] undo shutdown%Apr 5 07:25:56:244 2000 Sysname L2INF/5/PORT LINK STATUS CHANGE:- 1 -Ethernet1/0/1 is UP# After you disable Ethernet 1/0/1 from outputting Up/Down log information and execute the shutdowncommand or the undo shutdown command on Ethernet 1/0/1, no Up/Down log information is outputfor Ethernet 1/0/1.[Sysname-Ethernet1/0/1] undo enable log updown[Sysname-Ethernet1/0/1] shutdown[Sysname-Ethernet1/0/1] undo shutdownConfiguring Storm Control on a PortThe storm control function is used to control traffic received on an Ethernet port.z With traffic upper and lower thresholds specified on a port, the system periodically collectsstatistics about the broadcast/multicast traffic on the port. Once it finds that a type of traffic exceedsthe specified upper threshold, it blocks this type of traffic on the port or directly shuts down the port,and outputs trap/log information according to your configuration.
