1-18Operation Command DescriptionDisplay the topology of thecurrent clusterdisplay cluster current-topology[ mac-address mac-address1[ to-mac-address mac-address2 ] |member-id member-id1[ to-member-id member-id2 ] ]Display the information aboutthe base topology of the clusterdisplay cluster base-topology[ mac-address mac-address | membermember-id ]Display the information aboutall the devices in the basecluster topologydisplay cluster base-membersbe executed in anyview.When you display the cluster topology information, the devices attached to the switch that is listed in thebacklist will not be displayed.Configure cluster device blacklistFollow these steps to configure the cluster device blacklist on a management device:Operation Command DescriptionEnter system view system-view —Enter cluster view cluster —Add the MAC address of aspecified device to the clusterblacklistblack-list add-macmac-addressOptionalBy default, the cluster blacklistis empty.Delete the specified MACaddress from the clusterblacklistblack-list delete-macmac-address OptionalDelete a device from the clusteradd this device to the clusterblacklistdelete-member member-id[ to-black-list ] OptionalDisplays the information aboutthe devices in the clusterblacklistdisplay cluster black-listOptionalThis command can beexecuted in any view.Configuring the Cluster Synchronization FunctionAfter a cluster is established, to simplify the access and management to the cluster, you cansynchronize the SNMP configurations on the management device and the local user configurations tothe member devices of the cluster by configuring the cluster synchronization function.
