1-10Enabling system information display on the consoleAfter setting to output system information to the console, you need to enable the associated displayfunction to display the output information on the console.Table 1-9 Enable the system information display on the console:Operation Command DescriptionEnable the debugging/log/trapinformation terminal display function terminal monitor OptionalEnabled by default.Enable debugging informationterminal display function terminal debugging OptionalDisabled by default.Enable log information terminaldisplay function terminal logging OptionalEnabled by default.Enable trap information terminaldisplay function terminal trapping OptionalEnabled by default.Make sure that the debugging/log/trap information terminal display function is enabled (use theterminal monitor command) before you enable the corresponding terminal display function by usingthe terminal debugging, terminal logging, or terminal trapping command.Setting to Output System Information to a Monitor TerminalSystem information can also be output to a monitor terminal, which is a user terminal that has loginconnections through the AUX, VTY, or TTY user interface.Setting to output system information to a monitor terminalTable 1-10 Set to output system information to a monitor terminalOperation Command DescriptionEnter system view system-view —Enable the informationcenter info-center enable OptionalEnabled by default.Enable system informationoutput to Telnet terminal ordumb terminalinfo-center monitor channel{ channel-number |channel-name }OptionalBy default, a switch outputslog/debugging/trap information toa user terminal throughinformation channel 1.Configure the output rulesof system informationinfo-center source{ modu-name | default }channel { channel-number |channel-name } [ { log | trap |debug } { level severity | statestate } ]*OptionalRefer to Table 1-8 for the defaultoutput rules of system information.
