snmp trap addModify 733 Layer 2SwitchingModules3 MultilayerSwitchingModulessnmp trap addModify Adds or modifies trap reporting destination configurations. When anevent occurs, the system sends the trap that you specify here to thedestination address.Valid Minimum Abbreviationsn t aImportant Considerationsn You can define up to 10 destination addresses and the set of trapsthat are sent to each destination address.n No unlisted traps are transmitted.n Specify a range of more than two trap numbers with a hyphen (-) andnonsequential trap numbers with commas.n If the destination address that you entered is not a valid end station, ifa valid IP interface is not defined on the system, or if the agent doesnot have a route to the destination, the agent displays this message:Trap address invalid or unreachableIf you see this message, verify the IP address of the end station, that itis online, and that a route exists to the intended management station.n See the “Device Monitoring” chapter in the Switch 4007Implementation Guide for an explanation of what the individual trapsmean.OptionsPrompt Description Possible Values [Default]TrapdestinationaddressDestination IP address of theSNMP managerA valid destinationIP address–Trapnumbers toenableTraps that you want to directto the SNMP Managern A valid trap #,range, orsequence ofvalid trap #sn alln ? (for a list ofavailable trapnumbers)–
