3Com 4007 Command Reference Manual

Also see for 4007: Getting started guide Important notice Release note Implementation guide Product guide

Contents

3Com 4007 Command Reference Manual Manual pdf 281 page image

281ip riprouteAggregationLayer 2SwitchingModules3 MultilayerSwitchingModulesModeSets the route aggregation mode on a Multilayer Switching Module.Valid Minimum Abbreviationip ri roImportant Considerationsn Route aggregation mode determines which route table entries aresent during a RIP Version 2 update.n If route aggregation mode is enabled, RIP-2 can function like RIP-1and “collapse” route table entries for all subnets of a directlyconnected network. For example, if route aggregation is enabled,and the module is advertising subnets 150.100.31.0 and150.100.32.0, only the entry for network 150.100.0.0 is sent inthe update. With RIP Version 2, you must enable route aggregationmode if you want the interface to collapse the route table entriesand function like RIP-1.n If route aggregation mode is disabled (the default), a RIP-2update sends all routing table entries.OptionsPrompt Description Possible Values [Default]IP interfaces Index number of the interfacesfor which you want to set theroute aggregation moden One or moreselectableinterface indexesn alln ? (for a list ofselectableinterface indexes)Previousentry, ifapplicableRouteaggregationmodeWhether you want toimplement route aggregationon the selected interfacen disabledn enabledCurrentvalue