443Layer 2SwitchingModules3 MultilayerSwitchingModulesipx server static Defines a static IPX server on a Multilayer Switching Module.Valid Minimum Abbreviationipx ser stImportant Considerationsn Static servers remain in the table until you remove them, until youremove the corresponding interface, or until you remove the route tothe corresponding network address.n A static server must have an IPX network address that corresponds toa configured interface or to a static route. If an interface goes down,any static servers on that interface are permanently removed from theserver table until the interface comes back up.n Static servers take precedence over dynamically learned servers to thesame destination. You can have a maximum of 32 static servers.n Before you define static servers on the module, first define at least oneIPX interface. See “ipx interface define”earlier in this chapter for moredetails.OptionsPrompt Description Possible Values [Default]Interface index Interface index number for theservern A selectable IPXinterface indexn ? (for a list ofselectable IPXinterfaces)–Service type Number for the type of servicethat the server performsn *n 0x1 – 0xffff*Service name Service name of the server, up to79 charactersn Any selectableservice namen ? (for a list ofselectablenames)–IPX networkaddressIPX network address of the server 0x0 – 0xfffffffe –Socket value Socket value of the server 0x0 – 0xffff –Node address Node address of the server –Hops Number of hops to the server 0 – 15 –
