Menu
Vallox TSK Multi 80 MV Manual
Also see for 096 MV: Installation instructionsUser manualInstructions for use, maintenance and installationManualManual
                                                                                                            | |
Contents
| 
35© Vallox Oy - All rights reservedMAINTENANCECLEANING THE HEAT RECOVERY CELL(USER)Check that the heat recovery cell (D) is clean roughly once ayear when the filters are being replaced. Clean by washing asrequired.IMPORTANTHandle the cell carefully! For example, do not lift the cell by thelayers. The cell layers are very thin and easily damaged.To check the heat recovery cell (HR cell):1. Disconnect the ventilation unit from the mains electricitysupply.2. Lift the latch to open the door of the ventilation unit.3. Lift the door off.4. Pull the G4 filters (A, C) and filter supports out of the unit.5. Remove the sealing strip (E) above the HR cell.6. Remove the side sealing strip (F).7. Remove the G7 filter (B).8. Lift and pull the cell (D) out of the unit.9. If the cell is dirty, clean it by immersing it in warm water, towhich a small amount of a mild detergent has been added.10. Rinse the cell clean with a water spray. Do not use a high-pressure cleaner.11. When all the water has drained from between the layers,reassemble the ventilation unit in the reverse order.12. Close the door. Ensure that the safety switch catch of thedoor is touching the safety switch.13. Plug the ventilation unit back into the mains.14. The heat recovery cell has now been checked and cleaned.IMPORTANTIf the unit has an enthalpy cell, it must not be washed. Onlyaluminium or plastic cells can be washed. |
Related manuals for Vallox 096 MV
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved