65Programming/Editing Optional SettingsNotes:• If you select 0, the scanner stays on the system for aminimal time (only long enough to check currentsystem activity).• The default setting is 2 seconds for each system.• For conventional systems, all unlocked channels willbe scanned at least once regardless of this setting.• The scanner moves to the next system after the holdtime expires, any current transmission ends, and thechannel delay time expires.Setting the Channel Delay TimeJ program system J E 4Select the system J E 4Edit Sys Option J E 4Set DELAY TimeJ EThis setting controls how many seconds the scannerwaits after a transmission ends before resumingscanning. Enter a value from 1-5 or Off, then press E.Notes:• The default setting is 2 seconds for each system.• This setting applies to all channels within the system.Setting ID Scan/Search(Trunked Systems Only)J program system J E 4Select the system J E 4Edit Sys Option J E 4ID SCAN/SEARCHJ EThis setting controls how the system will be scanned.Select your setting, then press E.ID Scan - the scanner only stops on channels you haveprogrammed into the system.MenuMenu
