Toshiba strata CT Installation & Maintenance Manual

Also see for Strata CT: User guide Supervisor guide User guide Quick reference guide Guide

Contents

Peripheral Installation6-38 Strata CT I&M Manual October 2000Example 3 – DISA Outgoing Exchange Line CallNote DISA Exchange line calls print out as DISA.Call Sequence C Outside caller rings Exchange line 001. (Line 001 is programmed as DISA.) Line 001 returns intercom dial tone after two ring cycles (5~6 seconds). Caller dials #7003 to access Exchange line 003 (outgoing). Caller dials the DISA security code and receives Exchange dial tone. Caller dials the telephone number and converses when the call is answered. Caller hangs up. The call releases, and Printout C prints after the call disconnects at 12:22.Notes If the Exchange provides the Calling Party Control or Auto Release (AR) signal (seeProgram 15-0 and 15-3), the call disconnects when either party hangs up. A “*” willprecede the Exchange line number in Release 3 on the printout if the call isdisconnected by the CPC or AR signal. If the CPC or AR signal is not sent, the Exchange lines will remain seized until theDISA disconnect timer releases the call (see Program 12).Printout CAuto Release signal003 MSS 12:20 00:00;03 00:05 DISA (outgoing)*003 DISA 12:22 00:02;01 (outgoing)001 DISA 12:22 00:02;01 (incoming)Disconnect Timer001 DISA 12:24 00:04;57 (incoming)003 DISA 12:24 00:04;57 (outgoing)Note The “MSS” entry prints out only if the call was connected after the SMDRthreshold, 1.0 or 10 seconds. The threshold is set in Program 60-2.