Toshiba Q9+ Installation & Operation Manual

242 https://www.toshiba.com/tic/Direct Access Parameter InformationQ9 Plus ASD Install/Op ManualInput Function Target 3Program My Function My Function Unit 7This parameter plays a role in the setup of the My Function fea-ture by selecting the functionality of the programmable InputFunction Target 3 terminal.This setting assigns the function of the programmable InputFunction Target 3 terminal to any one of the user-selectable func-tions listed in Table 11 on pg. 256, Table 12 on pg. 257, or Table14 on pg. 260.See F977 for additional information on this parameter.Direct Access Number — F957Parameter Type — Selection ListFactory Default — 0 (Disabled)Changeable During Run — YesOutput Function AssignedProgram My Function My Function Unit 7This parameter plays a role in the setup of the My Function fea-ture by selecting the functionality of the Output FunctionAssigned terminal.This setting assigns the function of the programmable OutputFunction Assigned data location to one of the functions listed inthe Input Setting field of Table 12 on pg. 257.Settings:0 – 3099See the My Function Instruction Manual (P/N E6581335) andF977 for additional information on this parameter.Direct Access Number — F958Parameter Type — Selection ListFactory Default — 0 (Disabled)Changeable During Run — YesAnalog Input Function Target 11Program My Function My Function AnalogThis parameter plays a role in the setup of the My Function fea-ture by selecting the functionality of the programmable AnalogInput Function Target 11 terminal.The function selected at F961 may be adjusted using the inputanalog control signal selected here.Settings:0 — Disabled (None)1 — V/I2 — RR3 — RX4 — RX2+, RX2-5 — Optional V/I6 — Internal MemoryDirect Access Number — F959Parameter Type — Selection ListFactory Default — 0 (Disabled)Changeable During Run — YesF957 – F961