Toshiba Q9+ Installation & Operation Manual

236 https://www.toshiba.com/tic/Direct Access Parameter InformationQ9 Plus ASD Install/Op ManualMy Function Count Data 1Program My Function My Function DataThis parameter is used to set the pulse-count threshold valueused to trigger the discrete output COUNT1 (ON Timer).COUNT1 (ON Timer) outputs a 1 upon reaching the thresholdsetting of this parameter.Direct Access Number — F933Parameter Type — NumericalFactory Default — 0Changeable During Run — YesMinimum — 0Maximum — 9999Units — PulsesMy Function Count Data 2Program My Function My Function DataThis parameter is used to set the pulse-count threshold valueused to trigger the discrete output COUNT2 (ON Timer).COUNT2 (ON Timer) outputs a 1 upon reaching the thresholdsetting at this parameter.Direct Access Number — F934Parameter Type — NumericalFactory Default — 0Changeable During Run — YesMinimum — 0Maximum — 9999Units — PulsesInput Function Target 1Program My Function My Function Unit 4This parameter plays a role in the setup of the My Function fea-ture by selecting the functionality of the programmable InputFunction Target 1 terminal.This setting assigns the function of the programmable InputFunction Target 1 terminal to any one of the user-selectable func-tions listed in Table 11 on pg. 256, Table 12 on pg. 257, or Table14 on pg. 260.See F977 for additional information on this parameter.Direct Access Number — F935Parameter Type — Selection ListFactory Default — 0 (Disabled)Changeable During Run — YesInput Function Command 1Program My Function My Function Unit 4This parameter is used to assign a user-selected logical operatorto two user-selected Input Function Target variables, enable acounter/timer function, or perform a hold/reset function.Table 15 on pg. 262 lists the available selections. Their use andselection requirements are described in an example at F977.Direct Access Number — F936Parameter Type — Selection ListFactory Default — 0 (NOP)Changeable During Run — YesF933 – F937