Toshiba Q9+ Installation & Operation Manual

Direct Access Parameter InformationQ9 Plus ASD Install/Op Manualhttps://www.toshiba.com/tic/ 89Input Terminal 7 (S3) FunctionProgram Terminal Input TerminalsThis parameter is used to set the functionality of the S3 discreteinput terminal.In addition, this input terminal must be specified as NormallyOpen or Normally Closed.This parameter sets the programmable S3 terminal to one of theuser-selectable functions listed in Table 9 on page 252.Direct Access Number — F117Parameter Type — Selection ListFactory Default — Damper Feed-backChangeable During Run — NoInput Terminal 8 (S4) FunctionProgram Terminal Input TerminalsThis parameter is used to set the functionality of the S4 discreteinput terminal.In addition, this input terminal must be specified as NormallyOpen or Normally Closed.This parameter sets the programmable S4 terminal to one of theuser-selectable functions listed in Table 9 on page 252.Direct Access Number — F118Parameter Type — Selection ListFactory Default — Emergency OffChangeable During Run — NoInput Terminal 9 (LI1) FunctionProgram Terminal Input TerminalsThis parameter is used to set the functionality of the LI1 discreteinput terminal.In addition, this input terminal must be specified as NormallyOpen or Normally Closed.This setting assigns the function of the programmable LI1 termi-nal to one of the user-selectable functions listed in Table 9 onpage 252.Note: The Expansion IO Card Option 1 option board (P/NETB003Z) is required to use this terminal.See the Expansion IO Card Option 1 instruction manual (P/N58685) for additional information on the function of this terminal.Direct Access Number — F119Parameter Type — Selection ListFactory Default — UnassignedChangeable During Run — NoF117 – F120