Toshiba Perfecptione Installation And Maintenance Manual
TO HVSUCONNECTORON MAIN PCBINSIDETELEPHONE HSVI 8 /‘”Q iFIGURE4-27-HVSI/HVSUINSTALLATIONHKT65-20KSDROOM NOISEIHHEU\CONNECTORIHVSU -WIRECONNECTORW203FIGURE4-28ELECTRONICTELEPHONEPC8CONNECTIONSINSTALLATIONINSTRUCTIONSSECTION200-255-204FEBRUARY19925.25 Two pairs of the provided 3-pair modular lineconnector connect the electronic telephone to theDEKT port, and the other pair connects it to theNOCU PCB.5.26 NOCU connection details are shown in Figure4-29.5.30 Carbon Handset Transmitter Installation5.31 If a customer-supplied carbon-type handsetis used with the 6500-series electronic telephone,it is necessary to cut two jumper straps located onthe main PCB inside the telephone. Cut the jump-ers as follows:5.32 Loosen the four captive screws securing theelectronic telephone’s base, and remove the base(Figure 4-24).5.33 Locate the two carbon straps W201 and W202(Figure 4-30). Cut both straps.5.34 Cut the W401 strap for proper LCD functionsin A.05 (and below) software.5.35 Reinstall the electronic telephone’s base andsecure using the four captive screws.5.36 Remove the Toshiba handset and connectthe carbon-type handset.5.40 HHEU Installation5.41 The HHEU option provides the interface andcontrol for a customer-supplied headset.5.42 Loosen the four captive screws securing theelectronic telephone’s mounting base, and removethe base as shown in Figure 4-24.5.43 Using a screwdriver or other suitable tool,remove the plastic access tab located on the backof the mounting base (Figure 4-31). The HHEUmodular connector is accessed through this open-ing.5.44 Set HEADSET/EXT IO switch SW601 onthe HHEU PCB (Figure 4-32) to the HEADSETposition.4-23 |
Related manuals for Toshiba Perfecptione
This manual is suitable for:
Product
Menu
Learn More
Menu
Legal
Menu
Copyright © 2024 OneStart. All Rights Reserved