Menu
Toshiba Perfecptione Installation And Maintenance Manual
                                                                                                                                                                                                                                                                                                                                                                                |
CHAPTER 4SYSTEM INSTALLATION1. PERCEPTION,1.OOPower Supply installation1 .Ol Install the main power supply as follows:-INSTALLATIONINSTRUCTIONSSECTION200-255-204FEBRUARY19926) Check the 15amp fuse (Fl) located at the topof the power supply to verify that it is in workingorder.7) Remove plastic cover from AC connectionterminal TBl by removing two screws.8) Connect the white and black leads to the ACterminal (black to L and white to N) and thegreen lead (ground) to the GND screw on themain power supply (Figure 4-2). Replace theplastic cover and secure with two screws.1) Remove the two screws securing the basiccabinet front cover. Lift the cover off the cabinet.2) Loosen two screws, remove and retain fourscrews securing the basic cabinet rear coverplate, and remove the rear cover plate (Figure4-l).Ir 0\/fLOOSEN2 SCREWS- REMOVE4 SCREWS -)(FIGURE4-l-PERCEPTION@BASICCABINETREARCOVER3) Unpack the main power supply and inspect itcarefully for any visible damage. Verify that allconnectors are securely attached.4) Remove and retain the three corner screwsfrom the back of the main power supply.5) Slide the main power supply into the basiccabinet from the front and secure in place withthree screws at the rear.5515 - J509i- GROUND STRAPFIGURE4sP-PERCEPTION,CABLECONNECTIONS4-1 |
Related manuals for Toshiba Perfecptione
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved