Toshiba D-VR17KB Owner's Manual

Contents

ENIntroduction Connections Basic Setup Playback Editing VCR Functions OthersFunction SetupRecording73Accidental erasure preventionTo prevent accidental recording on a recordedcassette, remove its record tab. To record on it later,cover the hole with cellophane tape.One-touch Timer RecordingThis feature allows you to set the recording lengthsimply by pressing [REC I].1 Turn on the unit and insert arecordable tape.Make sure that the TV input is set on the unit.2 Press [VCR].3 Select the recording mode using[REC MODE]. (See page 72.)4 Select the desired channel to recordusing [PROG. / ] or[the Number buttons].5 Press [REC I] repeatedly until thedesired recording time (30 minutesto 8 hours) appears on the TVscreen.One-touch Timer Recording will start.• When the unit reaches the specified time, it will beturned off automatically.• To change the recording length during One-touchTimer Recording, press [REC I] repeatedly until thedesired length appears.• To cancel One-touch Timer Recording within thespecified time, press [STOP S].Hint• The remaining recording time will appear on the TVscreen during One-touch Timer Recording. Press[DISPLAY] to see it on the TV screen.Note• If VCR One-touch Timer Recording is completedduring DVD playback or recording, the VCR will bein stop mode and the DVD keeps the current mode.• You cannot use the pause function during One-touch Timer Recording.• When One-touch Timer Recording is finished andthe power is turned off, the unit will switch to thetimer-standby mode automatically if a timerrecording has been programmed. Press[TIMER SET] to cancel the timer-standby mode inorder to use the unit continuously.SearchIndex Search1 Press [VCR].2 Press [SEARCH] so that the indexsearch menu appears.3 Enter the number of recordings youwish to skip using[the Number buttons] within 30seconds.4 Press [FWD f] or [REV r] to startindex search.If you want to go in the forward direction, press[FWD f].If you want to go in the reverse direction, press[REV r].After index search, the VCR will play back thetape automatically.Note• This function is not available during recording.• Every time a tape is recorded, an index mark iswritten on the tape.• You can make the index mark up to 20.Time SearchThis feature allows you to go to a specific point on atape by entering the exact amount of time you wish toskip in order to reach the point.1 Press [VCR].2 Press [SEARCH] repeatedly until thetime search menu appears.3 Enter your desired time to skip using[the Number buttons] within 30seconds.4 Press [FWD f] or [REV r] to starttime search.If you want to go in the forward direction, press[FWD f].If you want to go in the reverse direction, press[REV r].After time search, the unit will play back the tapeautomatically.Note• This function is not available during recording.• Press [STOP S] to stop the search.• If the tape reaches the end during the search, thisunit will cancel it and rewind the tape.• You can set the time up to 9:59.Record tabVCRVCR0:308:00 7:301:00Normal RecordingVCRVCRVCRVCRE9GA0BD_EN.book Page 73 Monday, March 26, 2007 10:14 AM