Toshiba D-VR17KB Owner's Manual

Contents

22 ENInitial SettingTurn on this unit for the first time, you need to followthese steps.1 Press [ ON / STANDBY].2 Turn the TV on. Select the input towhich the unit is connected.3 Press [ENTER] to start Channel Tuning.The unit will start getting channels available inyour area.4 After finished channel setting,“Clock Setting” will appear. Thenpress [ENTER].5 Follow to step 5 on page 25 in“Manual Clock Setting”.Channel SettingTuning of this unit to broadcast channels can beperformed in two ways.Auto TuningProgramme the tuner to scan only the channels youcan receive in your area.1 In stop mode, press [SETUP]. Select“General Setting” using [U / D],then press [ENTER].General Setting Menu will appear.2 Select “Channel” using [U / D], thenpress [ENTER].3 Select “Auto Tuning” using [U / D],then press [ENTER].The unit will start storing channels available inyour area.Wait for several minutes to finish channel storing.4 Press [SETUP] to exit.You can select the channels memorised only inthis unit by using [PROG. / ].To cancel auto tuningPress [RETURN] or [SETUP] during scanning.Note• The selection will be affected by how you receive TVchannels in your local area.• If the auto tuning is cancelled during scanning,some channels not yet tuned may not be received.• You cannot change the channel when either VCR orDVD is in any recording mode (normal recording,One-touch Timer Recording or timer recording).• Sorting of TV channels from P01 to P06 will beperformed automatically as follows.P01: BBC1 P02: BBC2 P03: ITVP04: CH4 P05: CH5 P06: SKY NEWS• If you are using a satellite receiver, turn it on andselect SKY NEWS before commencing tuning.Basic SetupInitial SettingAuto TuningMake sure the antenna isconnected to “ANTENNA IN” jack.StartInitial SettingClock Setting- - / - - / - - - - ( - - - )- - : - -General SettingPlaybackDisplayVideoRecordingClockChannelDivXReset AllAuto TuningManual TuningMoveE9GA0BD_EN.book Page 22 Monday, March 26, 2007 10:14 AM