Toshiba D-VR17KB Owner's Manual

Contents

23ENIntroduction Connections Basic Setup Playback Editing VCR Functions OthersFunction SetupRecordingManual TuningManually tune each channel.1 In stop mode, press [SETUP]. Select“General Setting” using [U / D],then press [ENTER].2 Select “Channel” using [U / D], thenpress [ENTER].3 Select “Manual Tuning” using[U / D], then press [ENTER].4 Select “Position” using [U / D], thenpress [P].“P01” is highlighted.5 Select the position number you wishto use using [the Number buttons] or[U / D], then press [L].You can select position numbers 01 to 99.6 Select “Channel” using [U / D], thenpress [P].7 Press [U / D] to start scanning.• The tuner will begin to search up or downautomatically. When a channel is found, the unitwill stop searching and the picture will appearon the TV screen.• You can select a desired channel number using[the Number buttons]. Refer to the followingChannel Plan table and press the three digits toselect the channel number.(To select channel 4, press [0] first and thenpress [0] and [4]. Or press [4] and then “– – 4”appears and wait for 2 seconds.)• If this is the channel you want, press [L].This unit can receive the Hyper and Oscarfrequency bands.• If “Skip” is set to “ON”, select “Skip” using[U / D], then press [P]. Select “OFF” using[U / D], then press [L].• If you want to decode scrambled signals, select“Decoder” using [U / D], then press [P]. Select“ON” using [U / D], then press [L].• To store another channel, repeat steps 4 to 7.8 After completion, press [SETUP] toexit.To Select a ChannelYou can select a channel using [PROG. / ], ordirectly enter the channel using [the Numberbuttons] on the remote control.Notes on using [the Number buttons]:• Enter channel numbers as a two-digit number forthe quickest result. For example, to select channel6, press [0] and [6]. If you only press [6], channel 6will be selected after 2 seconds. You can only selectchannels 1 to 99.• You can select the external input mode “AV1”, “AV2”or “AV3”.• To select “AV1”, press [0], [0], [1].• To select “AV2”, press [0], [0], [2].• To select “AV3”, press [0], [0], [3].To Skip a Preset ChannelYou can set the unit to skip channels. You can nolonger receive or seldom watch when you accesschannels using [PROG. / ].1 Follow steps 1 to 3 in “ManualTuning” on page 23.2 Select “Position” using [U / D], thenpress [P].3 Select the position number you wishto skip using [the Number buttons]or [U / D], then press [L].4 Select “Skip” using [U / D], thenpress [P].5 Select “ON” using [U / D], thenpress [L].• To skip another channel, repeat steps 2 to 5.6 Press [SETUP] to exit.Channel PlanCH Indication TV Channel01 – 10 IRA-IRJ, GAP21 – 69 E21 – E6974 – 78 X, Y, Z, Z+1, Z+280 – 99, 100 S1 – S20, GAP121 – 141 S21 – S41Manual TuningChannelDecoderSkipPosition1OFFONP01E9GA0BD_EN.book Page 23 Monday, March 26, 2007 10:14 AM