221On-screen MessagesConnection with the Data Solution Box isnot correct. Please reset the system.Connection between the Communication Terminaland the Data Solution Box is not correct. Turn offthe Communication Terminal, then turn it on again.Fan in the Data Solution Box does not workproperly. The Data Solution Box is notusable.The fan equipped with the Data Solution Box is notworking properly. You cannot use the Data SolutionBox.The Whiteboard cannot be used. A videoconference with the whiteboard can be heldonly when the remote party uses the PCS-G50/G50P, PCS-G70/G70P, PCS-1/1P, PCS-11/11P, orPCS-TL50/TL50P.Battery in the stylus could be weak. Replacethe battery.The battery in the stylus for the whiteboard is low.Replace the battery in the stylus with a new one.The far-end system is not compatible withthe encryption feature.When conducting an encrypted videoconferencevia LAN, you cannot connect to the system that isnot compatible with the encryption via LANfeature.The encryption feature on a far-end systemis disabled.When conducting an encrypted videoconferencevia LAN, you cannot connect to the system if theencryption via LAN feature is deactivated.The encryption feature on a far-end systemis enabled.When conducting a daily conference, you cannotconnect to the system if the encryption via LANfeature is activated.The entered password for the encryptionfeature is not correct.Enter the correct password.The encrypted videoconference is notavailable if any terminal is connected viaISDN.While the videoconference is held via the ISDNconnection, you cannot connect any terminal viathe LAN connection if your encryption via LANfeature is activated.At least thirteen characters are required as apassword for the encryption feature.You have to enter 13 to 20 characters, numbers orsymbols as the password required for conduct of anencrypted videoconference via LAN.PPPoE connection has failed. LAN connection has failed. Check the PPPoEsetting.PPPoE server admission has failed. Access to a network is not admitted by the PPPoEserver.Connection to the PPPoE server fails. Check the DNS server setting.Communication via LAN is not available.Check the LAN cable.The connection to a LAN cannot be made. Checkthe LAN cable.An IP address is not obtained via DHCP. Check the DHCP setting.Please dial by entering the IP address. Be sure to enter the IP address of the remote partywhen dialing.Reference to DNS has failed. The LAN connection has failed as you entered theuser name when using the domain name server.Enter the IP address.Message Meaning
