189Using the Display ControlAt the beginning of the conference, the mode set for “Broadcast Mode” onpage 4 of the Communication Setup menu is applied. You can change themode during communication.1 Press the FAR/NEAR button on the Remote Commander.The Display Control menu appears.2 Use the V, v, B or b button on the Remote Commander to select“Broadcast Mode”, then press the PUSH ENTER button.Split: Selects the Split mode.Split (A Fixed): Specifies the picture of the terminal connected first to fixin the Split (Fixed) mode.Split (B Fixed): Specifies the picture of the terminal connected second tofix in the Split (Fixed) mode.Split (C Fixed): Specifies the picture of the terminal connected third to fixin the Split (Fixed) mode.Split (D Fixed): Specifies the picture of the terminal connected fourth tofix in the Split (Fixed) mode.Split (E Fixed): Specifies the picture of the terminal connected fifth to fixin the Split (Fixed) mode.Split (Near End Fixed): Fixes the local picture in the Split (Fixed) mode.Voice Activate: Selects the Voice Activate mode.Self Broadcast: Broadcasts the near end (local) party in the Broadcastmode.A Broadcast: Broadcasts the picture of the terminal connected first in theBroadcast mode.B Broadcast: Broadcasts the picture of the terminal connected second inthe Broadcast mode.C Broadcast: Broadcasts the picture of the terminal connected third in theBroadcast mode.D Broadcast: Broadcasts the picture of the terminal connected fourth inthe Broadcast mode.E Broadcast: Broadcasts the picture of the terminal connected fifth in theBroadcast mode.Stop Broadcast: Stops broadcasting in the Broadcast Mode.Switching the Broadcast ModeDisplay ControlDisplayFarControlNearCameraBroadcast ModeSplit
