Siemens SINUMERIK 840D sl Operating Manual

Also see for SINUMERIK 828D Turning: Diagnostic manual Function manual Equipment manual Programming manual Operating manual

PLC archive dataThe following settings are available for the "PLC archive data" and are activated when thepackage is executed:Origin of data NoteThis selection can be blocked by the project engineer in order to prevent changes by the operatorduring the package execution.Initial state If in the package configuration, "Package" > "Data areas" > "Use NCU/PPU"has been activated in the tab, the archive data can be loaded directly from thecontrol with the "initial state" setting.NoteNo data is reset when upgrading the CNC software. The archive that is availablein the system after data migration is used.Overall reset If this option is used, the PLC memory is overall reset and then the archive datais backed up.Offline archive If this option is used, the output data for the PLC area is taken from a storedSINUMERIK archive.Do not use If this option is used, no output data for this area is made available by the dialogpage.More information is provided in the notes in the Archive data transfer (packageexecution) (Page 218) section.Setting disabled Yes The selection at "Origin of data" can be blocked by the project engineer via thisoption in order to prevent changes by the operator during the package execution.NoPreselection of the offline archive At "Preselection of the offline archive", a SINUMERIK archive with PLC data(blocks) can be preselected, pasted, or inserted as link from the list.Alternatively, enter the path of a file which is located next to the package "//",e.g. "./sdb.arc".NoteWhen data for "Offline archive" is entered in the step tree via components, anarchive from the overall reset state must be saved here or the "Origin of thedata" must be set to "Overall reset".Create MyConfig - Expert4.4 Project folderSINUMERIK Integrate Create MyConfig - Diff, Expert, Topo190 Operating Manual, 12/2017, A5E36537479B-AE