Siemens SINUMERIK 840D sl Operating Manual

Also see for SINUMERIK 828D Turning: Diagnostic manual Function manual Equipment manual Programming manual Operating manual

Contents

Multi-channel machining (only 840D sl)9.2 Multi-channel support (only 840D sl)Turning568 Operating Manual, 03/2013, 6FC5398-8CP40-3BA1Procedure1. Press the "Block search" softkey.Press the "Search mode" softkey.The "Search Mode" window is displayed.2. Select the required mode for the channel group.3. Press the "OK" softkey to confirm the setting.4. Press the "Search text" softkey if you wish to enter the searchtarget using a text.- OR -Press the "Interrupt position" softkey if you wish to search for thesearch target using a program interrupt.- OR -Press the "Search pointer" softkey if you wish to enter a searchtarget that you cannot enter using the editor (e.g. no interruptposition, search target is located in the subprogram) and enterthe program path.5. Press the "Start search" softkey.The search starts.All channels of the group are started corresponding to the searchmode that has been set.During the block search, the search states are displayed in amessage window (e.g. "Block search running").You receive a message if the search target has been reached - oran error message if the search target was not found.NoteSearch target via "Search pointer"The "Search Pointer" window is displayed - as usual - over the complete lower part of thescreen. The upper contents of the window remain multi-channel.The actual channel is displayed in the title bar of the "Search Pointer" window.The "Delete search pointer" also only acts on this channel.