Programming technology functions (cycles)8.4 MillingTurningOperating Manual, 03/2013, 6FC5398-8CP40-3BA1 413Parameter Description UnitMachining • ∇ (roughing)• ∇∇∇ (finishing)• ∇∇∇ edge (edge finishing)• ChamferingFZ (only for Gcode)Depth infeed rate *Circular pattern • Full circleThe circumferential slots are positioned around a full circle. The distance from onecircumferential slot to the next circumferential slot is always the same and iscalculated by the control.• Pitch circleThe circumferential slots are positioned around a pitch circle. The distance fromone circumferential slot to the next circumferential slot can be defined using angleα2.X0Y0Z0(only for G code)The positions refer to the reference point:Reference point X – (only for single position)Reference point Y – (only for single position)Reference point Z – (only for single position)mmmmmmX0 or L0Y0 or C0Z0(only forShopTurn)Face C: The positions refer to the reference point:Reference point X or reference point length polar – (only for single position)Reference point Y or reference point angle polar – (only for single position)Reference point Z – (only for single position)mmmm ordegreesmmCPX0 or L0Y0 or C0Z0(only forShopTurn)Face Y: The positions refer to the reference point:Positioning angle for machining area – (only single position)Reference point X or reference point length polar – (only for single position)Reference point Y or reference point angle polar - (only for single position)Reference point Z - (only for single position)Degreesmmmm ordegreesmmY0 or C0Z0X0(only forShopTurn)Peripheral surface C: The positions refer to the reference point:Reference point Y or reference point angle polar - (only for single position)Reference point Z - (only for single position)Cylinder diameter ∅ – (only for single position)mm ordegreesmmmm
