Programming technology functions (cycles)8.5 Contour millingTurningOperating Manual, 03/2013, 6FC5398-8CP40-3BA1 469Parameter Description UnitMachiningsurface(only forShopTurn)• Face C• Face Y• Face B• Peripheral surface C• Peripheral surface Y(only forShopTurn)Clamp/release spindle (only for end face Y/B and peripheral surface Y)The function must be set up by the machine manufacturer.Machining The following machining operations can be selected:• ∇ (roughing)• ∇∇∇ base (base finishing)• ∇∇∇ edge (edge finishing)• ChamferingZ0 Reference point in tool axis Z mmZ1 Pocket depth (abs) or depth referred to Z0 or X0 (inc) mmCP Positioning angle for machining area- (only for ShopTurn, machining surface, face Y)DegreesC0 Positioning angle for machining surface- (only for ShopTurn, machining surface, peripheral surface Y)DegreesDXY• Maximum plane infeed• Maximum plane infeed as a percentage of the milling cutter diameter- (only for ∇ and ∇∇∇ base)mm%DZ Maximum depth infeed– (only for ∇ or ∇∇∇ edge)mmUXY Finishing allowance, plane– (only for ∇, ∇∇∇ base or ∇∇∇ edge)mmUZ Finishing allowance, depth– (only for ∇ or ∇∇∇ base)mmLift mode Lift mode before new infeedIf the machining operation requires several points of insertion, the retraction height canbe programmed:• To retraction plane• Z0 + safety clearanceWhen making the transition to the next insertion point, the tool returns to this height. Ifthere are no elements larger than Z0 (X0) in the pocket area, then Z0 (X0) + safetyclearance can be programmed as the lift mode.mmmmmmFS Chamfer width for chamfering - (only for chamfering machining) mmZFS Insertion depth of tool tip (abs or inc) - (for chamfering machining only) mm
