Siemens SINUMERIK 840D sl Operating Manual

Also see for SINUMERIK 828D Turning: Diagnostic manual Function manual Equipment manual Programming manual Operating manual

Contents

Programming technology functions (cycles)8.3 Contour turningTurningOperating Manual, 03/2013, 6FC5398-8CP40-3BA1 359Parameters, G code program Parameters, ShopTurn programPRG Name of the program to begeneratedT Tool namePL Machining plane D Cutting edge numberRP Retraction plane –(only for machiningdirection,longitudinal, inner)mm F Feed (∇ or ∇∇∇) mm/revSC Safety clearance mm FS Finishing feedrate (onlyfor complete machining:∇ + ∇∇∇)mm/revF Feed (∇ or ∇∇∇) * S / V Spindle speed orconstant cutting ratem/minFS Finishing feedrate(only for completemachining: ∇ + ∇∇∇)*ResidualmaterialWith subsequent residual materialremoval• Yes• NoCONR Name to save the updated blankcontour for residual materialremovalParameter Description UnitMachining • ∇ (roughing)• ∇∇∇ (finishing)• ∇ + ∇∇∇ (roughing and finishing)• Face• Longitudinal• Parallel to the contour• From inside to outside• From outside to inside• From end face to rear side• From rear side to end faceMachiningdirectionThe machining direction depends on the stock removal direction and choice of tool.