Siemens Acuson S1000 Instructions For Use Manual

Also see for Acuson S2000: Installation instructions

9 e S i e F u s i o n I m a g i n g9 - 1 0 I n s t r u c t i o n s f o r U s eTo Do thisRename an entry in theNavigator1. Double-click the entry text in the list.2. Enter the new name in the text box and then press Enter on the keyboard.The system updates the name in the Navigator and on the image.Note: If the new name exceeds the available space, the system displays anellipsis (…) at the end of the name.Permanently remove planningdata or alignments from theimage Select the check box for the required entries and then click Delete.The system removes the markers for the selected entries from the image andremoves the corresponding entries from the Navigator.Temporarily remove selectedplanning data on the image Select the check boxes for the required entries and then click Hide.The system removes the markers on the image for the selected entries. To redisplay hidden planning data, select the check boxes for the requiredentries and then click Show.Limit the list of entries in theNavigator1. Click the current Filter Navigator List selection and then select the entries toinclude in the Navigator:– Show All displays all entries for planning data and alignments.– Show Segmentation displays only the entries for outlines created using linesegmentation or seed segmentation.– Show Needle Path displays only the entries for planned needle paths.– Show Marker displays only the entries for landmarks.– Show Point Correspondence displays only the entries for pairs of alignmentmarkers. (Available only when point alignment is activated.)– Show Alignment displays only the entries for saved alignments.– The Navigator displays only the selected entries in the list.2. To redisplay all entries in the Navigator, click Show All.