Menu
Samsung iDCS 500 Technical Manual
Also see for iDCS 500: User guideUser guideUser guideAdministration guideUser instruction
                                                                                                                                         |
iDCS 500 Release 2 / OfficeServ INSTALLATIONTECHNICAL MANUAL PART 3 MARCH 20043.4DIP SWITCH USEon theiDCS 500 MCP2ON (left) OFF (right)4 DIGIT STATION NUMBERS SW8 3 DIGIT STATION NUMBERS4 DIGIT STATION GROUPS SW7 3 DIGIT STATION GROUPS4 DIGIT TRUNK NUMBERS SW6 3 DIGIT TRUNK NUMBERSRESERVED SW5 RESERVEDCOUNTRY SELECT SW4 COUNTRY SELECTCOUNTRY SELECT SW3 COUNTRY SELECTCOUNTRY SELECT SW2 COUNTRY SELECTCOUNTRY SELECT SW 1 COUNTRY SELECTz Switches 1 through 4 select the country the system is installed in.4 3 2 1 CountryOFF OFF OFF OFF KoreaOFF OFF OFF ON USAOFF OFF ON OFF UKOFF OFF ON ON ItalyOFF ON OFF OFF AustraliaOFF ON OFF ON New ZealandOFF ON ON OFF HollandOFF ON ON ON Denmarkz Switch 5 reserved.z These DIP switches will not take effect unless the switches are set in the wantedposition and the system memory is cleared manually by using the Memory Backupswitch.Install the SmartMedia card. Install daughter board(s). Set the MCP2 DIP switches on thecard to the desired positions. Turn the memory switch on.Insert MCP2 card in the Cabinet slot labeled MCP/LCP (see Figure 3–1). Push firmly atthe top and bottom of the card to ensure that it is fully inserted into the back planeconnector. To prevent accidental damage to the MCP2 card, the MCP/LCP connectoron the back plane is positioned to mate only with the MCP2 or LCP2 card. Otherinterface cards will not mate with this connector and the MCP2 card will not mate withany other connector. NOTE: Do not insert this card with system power ON. |
Related manuals for Samsung iDCS 500
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved