T ROUBLESHOOTING9.2Clearing Document JamsWhen a document jams while it passes through the ADF (AutomaticDocument Feeder), “[Document Jam]” appears on the display.1 Remove the remaining documents from the ADF.2 Pull the jammed document gently out of the ADF and skipto step 5.If there is any resistance and the document does not movewhen you pull it, continue to the next step.3 Open the control panel by gripping its top and pulling on it.4 Pull the document gently out of the ADF and close thecontrol panel.5 Load the documents back into the ADF.NOTE: To prevent document jams, do not use thick, thin or mixeddocuments.C AUTION: When closing the ope control, strongly push the LCDprojection part in the center portion of ope control. If it is not fullyclosed, JAM is likely to occur.