3–Fibre Channel ConfigurationConfiguring Target Persistent Binding44 BK3254601-00 CConfiguring Target Persistent BindingUse QConvergeConsole to configure target persistent binding: Configuring Persistent Binding with QConvergeConsole GUI Configuring Persistent Binding with Interactive QConvergeConsole CLI Configuring Persistent Binding with Noninteractive QConvergeConsole CLIConfiguring Persistent Binding with QConvergeConsole GUITo bind target devices attached to an adapter port usingQConvergeConsole GUI:1. In the system tree, expand a Fibre Channel node.2. In the system tree for a 2700 Series Adapter, select the physical portnumber.3. Click the Targets tab, and then click the Target Persistent Binding tab.4. Choose the binding options: Select the Bind All check box to bind all the devices listed to adapterports. Select the Bind check box if you want to configure a specific port andbind it to the target ID that you have selected from the Target ID list. Ifyou do not want to configure the port, clear the check box. If you clearthe check box, the corresponding port is unconfigured.5. To save the configuration changes, click Save.6. If the Security Check dialog box appears, type the password in the EnterPassword box, and then click OK.7. The system overwrites any previously saved configuration for the currentadapter and displays a message box. Click OK to close the message box.For more information, refer to the topic about binding target devices in theQConvergeConsole Help.NOTETarget persistent binding is supported only on Windows.
