3–Fibre Channel ConfigurationUsing Fast!UTIL for Custom Configuration40 BK3254601-00 C7. To specify an alternate boot device on the 2700 Series Adapter, use thearrow keys to move to the next available alternate entry, press ENTER,select the disk drive you want, and press ENTER again. You can specify upto three alternate boot devices in this way.Restore Default SettingsThe Restore Defaults option restores the BIOS settings back to default.Raw NVRAM DataThe Raw NVRAM Data option displays the 2700 Series Adapter’s NVRAMcontents in hexadecimal format. This option is a QLogic troubleshooting tool; youcannot modify the raw NVRAM data.Advanced Adapter SettingsOn the Configuration Settings menu in Fast!UTIL, select Advanced AdapterSettings. Table 3-3 describes the default settings for the 2700 Series Adapters.NOTESystem BIOS compatibility: To boot from a QLogic host 2700 Series Adapterin a computer system with a multiboot system BIOS, the 2700 SeriesAdapter must be included in the list of bootable devices in the system’s Bootmenu.Table 3-3. Advanced Adapter SettingsSetting Values Default DescriptionLUNs perTarget0, 8, 16, 32,64, 128,256128 This setting specifies the number of LUNs supported pertarget if the target does not support the Report LUN com-mand. Multiple LUN support is typically for redundant arrayof independent disks (RAID) boxes that use LUNs to mapdrives.Enable LIPReset aYes, No No This setting determines the type of loop initialization pro-cess (LIP) reset used when the OS initiates a bus reset rou-tine as follows: Yes = The driver initiates a global LIP reset to reset thetarget devices. No = The driver initiates a global LIP reset with full login.Enable LIPFull Login aYes, No Yes When this setting is Yes, the 2700 Series Adapter’s reducedinstruction set computer (RISC) controller log in to all portsafter any LIP.
