26 SD memory card[SD memory card]Select "Use" or "Not use" to determine whether or not touse the SD memory card.Default: UseImportant:• Select "Not use" when operating without a SD mem-ory card.• Before removing the SD memory card from the cam-era, it is necessary to select "Not use" first.• After inserting the SD memory card, it is necessaryto select "Use" to use the SD memory card.• When playing or downloading images saved on theSD memory card, it is necessary to select "On" for"Save logs" on the [Log] tab ( page 32) inadvance.• When the image refresh interval is short, notifica-tion/recording timing or interval may become incor-rect. Notification/recording may also not be per-formed correctly as configured when multiple usersare receiving images. In this case, set the refreshinterval longer.• There are limited times to overwrite on an SD mem-ory card. When having a high frequency of overwrit-ing, the lifetime of the SD memory card may becomeshorter.[Remaining capacity notification]When the mail notification function or the Panasonicalarm protocol function is used to provide notification ofthe remaining capacity of the SD memory card, select alevel to be notified at from the following.50%/20%/10%/5%/2%Default: 50%Note:• Notification will be provided each time the remainingcapacity of the SD memory card reached the valuesabove.For example, notification will be provided each timethe remaining capacity reaches 50%, 20%, 10%, 5%and 2% when "50%" is selected. Notification may notalways be made at the very moment when theremaining capacity of the SD memory card hasreached each value.Configure the settings relating to the SD memory card [SD memory card]Click the [SD memory card] tab on the "Basic" page. ( pages 20 and 21: How to display/operate the setup menu)The settings relating to the SD memory card can be configured on this page.Important:• It is impossible to display images and to receive/transmit audio between the camera and the PCwhen the viewer software "Network Camera View4"is not installed on the PC.• The number of the viewer software installations canbe checked on the [Upgrade] tab of the"Maintenance" page.
