40Configure the settings relating to MPEG-4 images [JPEG/MPEG-4]Click the [JPEG/MPEG-4] tab on the "Image/Audio" page. ( pages 20 and 21: How to display/operate the setupmenu)The [JPEG/MPEG-4] tab will be displayed when "MPEG-4" is selected for "Video encoding format". ( page 37)Configure the settings relating to MPEG-4 image such as "Max bit rate (per client)*", "Image capture size", "Imagequality", etc. in this section.Refer to page 37 and 36 for the settings relating to H.264 images and JPEG images respectively. MPEG-4(1) · MPEG-4(2)[MPEG-4 transmission]Select "On" or "Off" to determine whether or not totransmit MPEG-4 images.On: Transmits MPEG-4 images.Off: Does not transmit MPEG-4 images.Default: OnNote:• When "On" is selected for "MPEG-4 transmission" in“MPEG-4 (1)”, displaying of both MPEG-4 imagesand JPEG images on the “Live” page will becomeavailable.• When "On" is selected for "MPEG-4 transmission" in"MPEG-4(1)" and "MPEG-4(2)", MPEG-4 images areviewable using other devices with each setting.• When “On” is selected for “MPEG-4 transmission” in“MPEG-4(1)” or “MPEG-4(2)”, the transmission inter-val of JPEG images may sometimes become longer.[Internet mode (over HTTP)]Select "On" when transmitting MPEG-4 images via theInternet. It is possible to transmit MPEG-4 images with-out changing the broadband router settings configuredfor JPEG image transmission.On: MPEG-4 images and audio will be transmittedusing the HTTP port. Refer to page 73 for furtherinformation about the HTTP port number settings.Off: MPEG-4 images and audio will be transmittedusing the UDP port.Default: OffNote:• When "On" is selected, only "Unicast port (AUTO)"will be available for "Transmission type".• When "On" is selected, it may take seconds to startdisplaying MPEG-4 images.• When "On" is selected, MPEG-4 images may not bedisplayed depending on the number of the concur-rent access users and audio data availability, etc.
