Panasonic WV-LC1710 Operating Instructions Manual

Also see for WVLC1710 - LCD MONITOR: Specifications

Contents

Panasonic WV-LC1710 Operating Instructions Manual Manual pdf 6 page image

6• Built-in high resolution (SXGA) panel with high contrast ratio,wide view angle and true 8 bit full color.• Selectable inputs, including Composite Video, S-Video,Component Video and analog RGB signal input for personalcomputer (PC).• Automatically switchable NTSC and PAL system.• PC display capacity which can support VGA (640 × 480) ~ SXGA(1280 × 1024) resolutions. Picture size and position can be auto-matically adjusted.• One audio input and output with built in maximum speaker outputof 0.5 W.• Refer all work related to the installation of this product toqualified personnel or system installers.• Do not block the ventilation slots on the cover.To prevent the appliance from overheating, place it at least 5 cm{2 inches} away from the wall.• Do not drop metallic parts through the slots.This could permanently damage the appliance. Turn the power offimmediately and contact qualified service personnel for service.• Do not attempt to disassemble the appliance.To prevent electric shock, do not remove screws or covers. Thereare no user-serviceable parts inside. Contact qualified servicepersonnel for maintenance.• Handle the appliance with care.Do not strike or shake it, as this may damage the appliance.• Do not expose the appliance to rain or moisture nor tryto operate it in wet areas.Take immediate action if the appliance becomes wet. Turn thepower off and refer to qualified service personnel.Moisture may damage the appliance and also cause electricshock.• Do not operate the appliance beyond its specified tem-perature, humidity or power source ratings.Use the appliance at temperatures within 0 °C ~ +40 °C {32 °F ~104 °F} and humidity below 90 %.The input power source for this appliance is 100 V AC to 240 VAC, 50/60 Hz with AC Adapter.• Do not use strong or abrasive detergents when cleaningthe appliance body.Use a dry cloth to clean the appliance when it is dirty. Whenthe dirt is hard to remove, use a mild detergent and wipe gently.Afterwards, wipe the remained part of the detergent in it witha dry cloth.• The surface of the display panel is applied by specialcoating.Do not point hard objects and wipe by abrasive material. It cancause scratches and damages on the display panel.• The display panel is made from a very precise technol-ogy.Some bright and dark spots may exist on the screen. It is operat-ing normally if there are 99.99 % active pixels.• Use the supplied AC Adapter.Other AC Adapters cannot be used.• When turning off the power supply of AC Adapter, unplugthe power supply cord or cut the power supply through thebreaker in the panel board connecting to this equipment.When installing this equipment again, place where the power sup-ply plug socket and breaker easily be reached.• Onscreen setup menu.• Auto-volt power supply from 100 V AC ~ 240 V AC (AC Adapter).Note: The included AC power cord is for 120 V AC only. It isnecessary to change the AC power cord when using other powersupply other than 120 V AC.• Metal cabinet casing. It can be mounted in an EIA standard rackusing an optional rack mount bracket.• The mounting holes for wall mount located on the rear sideof the monitor comply with VESA standard. It can be mount-ed in the wall by installing a commercialized wall mount.VESA: Video Electronics Standards AssociationThis monitor is a 17" type LCD Monitor, using a motion adaption IPconversion circuit and Y/C separation circuit for high definition andhigh resolution of picture display.PREFACEFEATURESPRECAUTIONS