Panasonic WV-LC1710 Operating Instructions Manual

Also see for WVLC1710 - LCD MONITOR: Specifications

Contents

Panasonic WV-LC1710 Operating Instructions Manual Manual pdf 19 page image

19Notes:• H-POSITION, V-POSITION, CLOCK and PHASE willchange depending on the input signal.Normally, these parameters need not to be set.In case the position of the picture is still shifted evenAUTO TUNING button is pressed, operate base on theprocedure below.1. Set the left edge of the picture to the left edge of themonitor screen while adjusting H-POSITION.2. Set the right edge of the picture to the right edge of themonitor screen while adjusting CLOCK.3. Repeat steps 2 and 3 until the position of the picture ison the center of the screen.• OSD H-POSITION and OSD V-POSITION settings can-not be reset.• Adjustment parameters from PC are not supported.CONNECTING WITH WJ-HD300 SERIES• There is a possibility that the picture will be shifted if theMonitor (VGA) terminal of the Digital Disk Recorder WJ-HD300 series is connected to the PC input even AUTObutton is pressed. In this case, adjust H-POSITIONand CLOCK following the procedure indicated in upperleft note.Picture-in-Picture Mode MonitoringThe input signal of subscreen displays on the upper right ofdisplay panel.2. After displaying the subscreen, pressing the POS button willmove the subscreen as shown below.7. After setting the parameters, press the MENU button.Set values will be stored and the Video Adjustment Menu willexit.Caution:• If power is cut off setting, it will not store the settingsthat have changed.3. Press the INPUT SELECT button in selecting Video, S-Video,or Component input that appears on the subscreen when PCinput is currently on the main screen.VIDEO1. Press the PIP button to display the subscreen in approxi-mately 2 seconds waiting time, as shown below.• PC Input is displayed in subscreen when Composite Video,S-Video or Component Video inputs is displayed on mainscreen of the monitor.• VIDEO, S-VIDEO or COMPONENT is displayed in subscreendepending on the last input done prior to switching to PC Inputwhen PC input is displayed on main screen of the monitor.3 42 1