351 Select “SIDE BAR ADJUST”.2 Adjust the menu.OFFOFFBRIGHTSIDE BAR ADJUSTSCREENSAVERSTARTWOBBLINGPEAK LIMITFUNCTION NEGATIVE IMAGE2 change1 selectOFF DARK MID BRIGHT3 Exit from SCREENSAVER.orThese functions prevent the occurrence of an “image retention” on the display when turned ON.WOBBLING: Automatically shifts the display image (therefore unnoticeable to the eye) to prevent image retention ofsharper contour of image.ON1: Shifts the image every 30 seconds.ON2: Shifts the image at a dot level pitch depending on screen-detection.PEAK LIMIT: Suppresses image contrast (peak brightness).Note: When a still picture is viewed for an extended time, the screen may become slightly darker. (see page 45)Reduces screen image retentionSIDE BAR ADJUSTDo not display a picture in 4:3 mode for an extended period,as this can cause an image retention to remain on the sidebars on either side of the display field.To reduce the risk of such an image retention, illuminate theside bars.This function may be applicable to the non-picture area.Notes:To reduce the occurrence of image retention, set the “SIDE BAR ADJUST” to “BRIGHT”.The side bar may flash (alternate black/white) depending on the picture being shown on the screen. Using Cinemamode will reduce such flashing.••Side bars4:3 modeImageretentionSCREENSAVER (For preventing image retention)1 Select “WOBBLING” or “PEAK LIMIT”.2 Select “ON1”, “ON2” or “OFF”(WOBBLING).Select “ON” or “OFF” (PEAKLIMIT). OFFOFFBRIGHTSIDE BAR ADJUSTSCREENSAVERSTARTWOBBLINGPEAK LIMITFUNCTION NEGATIVE IMAGE2 change1 select