Part Names and Functions9English■ Control panelPanel Name DescriptionContrast/RemainingFilmIndicatorThis lamp indicator notifies the user when the time to replace thethermal transfer film is approaching (estimated) and of theprinting contrast used during copying.Indicator off: Normal printing contrastIndicator on: Darker than normal printing contrastIndicator flashing*: Almost time to replace the thermal transferfilm(Note that only about 15 more sheets may becopied when this indicator starts flashing.)Replacement film (UG-6001) is separately availablefrom the dealer where you purchased your unit.* The flashing indicator will go out after the power is turned off, or theprinter has been opened and closed. (When copying is performed, thisindicator will begin flashing again.)ContrastKeyEach time this key is pressed, the unit will alternate betweennormal and dark contrast modes (Normal/Dark).2-ScreenCopy KeyThis key causes the front and back of the screen to be copied ona single sheet of paper.Multi-Copy/ErrorIndicatorThis indicator displays the number of copies to be made. Thedisplay changes each time the Multi-Copy/Stop Key is pressed.Example: 1 → 2 → ··· → 9 → 1 → ···When an error occurred, a flashing symbol will appear in this display toindicate the error status. (See page 27.)Multi-Copy/Stop KeyWhen making multiple copies, press this key until the desirednumber of copies is displayed on the Multi-Copy/Error Indicator.This key can also be pressed to stop copying while executingmultiple copies.• The display changes as shown below each time the screen is copied. Afterreaching 0, the display will reset to 1.Example: 5 → 4 → 3 → 2 → 1 → 0 → 1(Number is counted down.)Copy Key This key causes the screen to be copied.AdvanceKey Pressing this key advances the screen from right to left.Contrast/Remaining FilmIndicatorAdvance KeyMulti-Copy/Error IndicatorMulti-Copy/Stop KeyCopy KeyContrast Key2-Screen Copy Key