Panasonic UB-5325 Operating Instructions Manual

Also see for UB-5325: Installation manual

Panasonic UB-5325 Operating Instructions Manual Manual pdf 22 page image

Computer Interfacing22■ Panaboard Operation PanelIt is possible to perform the same operations as with the electronic board control panel (page 9) from the followingPanaboard Operation buttons.Note• While the Panaboard Operation Panel is displayed, the Copy Key and 2-Screen Copy Key on the electronicboard control panel are used for scanning images into the computer.Panel Name DescriptionContrast/Remaining FilmIndicatorThis lamp indicator notifies the user when the time toreplace the thermal transfer film is approaching (estimated)and of the contrast used during scanning or copying.Indicator off: Normal scanning or copying contrastIndicator on: Darker than normal scanning orcopying contrastIndicator flashing*: Almost time to replace the thermaltransfer film(Note that only about 15 more sheets maybe copied when this indicator startsflashing.)Replacement film (UG-6001) is separatelyavailable from the dealer where you purchasedyour unit.* The flashing indicator will go out after the power is turned off, orthe printer has been opened and closed. (When copying is per-formed, this indicator will begin flashing again.)Contrast Button Each time this button is pressed, the unit will alternatebetween normal and dark contrast modes (Normal/Dark).2-Screen ScanButtonThis button scans the front and back of the screen on asingle page.Multi-Copy/Error IndicatorThis indicator displays the number of copies to be made.The display changes each time the Multi-Copy/Stop Buttonis pressed.Example: 1 → 2 → ··· → 9 → 1 → ···When an error occurs, a flashing symbol will appear in this display toindicate the error status. (See page 27.)Multi-Copy/StopButtonWhen making multiple copies, press this button until thedesired number of copies is displayed on the Multi-Copy/Error Indicator. This button can also be pressed to stopcopying while executing multiple copies.• The display changes as shown below each time the screen is copied.After reaching 0, the display will reset to 1.Example: 5 → 4 → 3 → 2 → 1 → 0 → 1(Number is counted down.)* If scanning, the setting 1 to 9 for the number of copies isignored.Scan Button This button scans the screen.Advance Button Clicking this button advances the screen from right to left.