Panasonic TX32DTX-40 Operating Instructions Manual

Panasonic TX32DTX-40 Operating Instructions Manual Manual pdf 32 page image

3232Your new TV is supplied with programme position ‘0’ set to receive an RF signal from your VCR or DVD Recorder, although a Scartconnection is preferable if the device is so equipped.However, if for some reason your VCR or DVD Recorder is tuned to a different RF channel then you will not receive any picture or soundfrom your device on programme position ‘0’ of the TV. It will be necessary to either adjust the RF channel of your device (some device’sallow adjustment of their RF channel via their remote control unit) or to adjust the tuning of the TV’s programme position ‘0’ or both untilit receives the RF output channel of your VCR or DVD Recorder.It is intended that this advice is used in conjunction with the instruction books for your additional equipment.Use the AV2 Scart terminal for an S--Video, Q--Link, NEXTVIEWLINK or compatible VCR or DVD Recorder.To tune your TV to the recording deviceSwitch on the device, insert and play a pre--recorded tape or discwith known content.(1) (2) (3) (4) (5)F STR--/vOn the TV, select programme position “0 ---VCR” (1).Open the Front panel flap.Press the F button (2) repeatedly until “Tuning mode” is reached.Press the -- or + button (3) or (4) to access Tuning mode.Press -- or + (3) or (4) to begin searching for the device’s playback.When the playback is found, press the STR button (5) to store theprogramme position.The programme position and channel number indicators will flash toindicate the station is being stored.To exit Manual Tuning, press the F button (2).Note:If picture patterning occurs on programme position ‘0’ it may benecessary to adjust the RF output channel of the recording device, referto the device’s instruction book.VCR / DVD RECORDER INSTALLATION