Panasonic TX32DTX-40 Operating Instructions Manual

Panasonic TX32DTX-40 Operating Instructions Manual Manual pdf 21 page image

21To add an analogue programme positionUsing the Menu button (1), open the Main Menu.Access the Setup menu.Move to Analogue Tuning menu (2).Access Analogue Tuning menu (3).Move to Manual tuning (2).Access Manual tuning (3).Press the left or right cursor buttons repeatedly until the requiredstation is found (3).Press OK to store the programme position (4).Press Setup to return to the Tuning menu (1).If you have finished in the Tuning menu, press the EXIT button toexit (5).(1) (2) (3) (4) (5)Shipping condition allows you to reset the TV to its original condition, i.e. no channels tuned in.This is useful, for example, if you move to a different area when you will probably want the TV to tune itself to your new local stations.This function is available in both analogue and DVB modes.The Shipping condition menu will reset all data, clearing all analogue and DVB tuning information and resetting all control levels back tofactory settings.You may need to adjust your VCR or programme position ‘0’ VCR after operating the Shipping condition menu -- refer to page 32.Using the Menu button (1), open the Main Menu.Access the Setup menu.In analogue mode, move to Analogue Tuning menu (2).In analogue mode, access Analogue Tuning menu (3).Move to Shipping condition (2).Access Shipping condition (3).Press OK to start (4).Press OK again, to confirm, each time that you are asked,“Are you sure?” (4).Switch TV off and wait for a few seconds.Switch TV on again.Auto setup will begin, followed by DVB Scanning. Analogue and DVBstations will be located, sorted and stored ready for use. See page 20.(1) (2) (3) (4)ANALOGUE TUNING MENU -- MANUAL TUNINGSHIPPING CONDITION