English - 5 -Assembling / Removing the pedestalPreparationsTake out the pedestal(s) and the TV from the packingcase and put the TV onto a work table with the screenpanel down on the clean and soft cloth (blanket, etc.)• Use a flat and firm table bigger than the TV.• Do not hold the screen panel part.• Make sure not to scratch or break the TV.Assembling the pedestal1. Place the stand(s) on the stand mountingpattern(s) on the rear side of the TV.2. Insert the screws (M4 x 12) provided and tightenthem gently until the stand is properly fitted.Removing the pedestal from the TVBe sure to remove the pedestal in the following waywhen using the wall-hanging bracket or repackingthe TV.• Put the TV onto a work table with the screen paneldown on the clean and soft cloth. Leave the stand(s)protruding over the edge of the surface.• Unsrew the screws that fixing the stand(s).• Remove the stand(s).When using the wall-hanging bracketPlease contact your local Panasonic dealer topurchase the recommended wall-hanging bracket.Holes for wall-hanging bracket installation;Rear of the TVaba (mm) 200b (mm) 200View from the sideaDepth ofscrew (a)min. (mm) 5max. (mm) 10Diameter M6Note: The screws for fixing the TV onto the wall-hangingbracket are not supplied with the TV.Environmental InformationThis television is designed to be environment friendly.To reduce energy consumption, you can follow thesesteps:If you set the Energy Saving to Minimum, Medium,Maximum or Auto the TV will reduce the energyconsumption accordingly. If you like to set theBacklight to a fixed value set as Custom and adjustthe Backlight (located under the Energy Savingsetting) manually using Left or Right buttons on theremote. Set as Off to turn this setting off.Note: Available Energy Saving options may differ dependingon the selected Mode in the Picture menu.The Energy Saving settings can be found in thePicture menu. Note that some picture settings willbe unavailable to be changed.