Panasonic TX-40C320E Operating Instructions Manual

Panasonic TX-40C320E Operating Instructions Manual Manual pdf 10 page image

English - 10 -ConnectionsConnector Type Cables DeviceScartConnection(back)VGAConnection(back)SIDE AV PC/YPbPrAudioConnection(side) YPbPr/PC Audio Cable (notsupplied)HDMIConnection(back)SPDIF SPDIF(Optical Out)Connection(back)SIDE AV Side AV(Audio/Video)Connection(side) AV Cable (not supplied)HEADPHONE HeadphoneConnection(side)YPBPR YPbPr VideoConnection(back) PC to YPbPr Connection Cable(not supplied)USBConnection(side)CIConnection(side)CAMmoduleLAN EthernetConnection(back) LAN / Ethernet CableNOTE: When connectinga device via the YPbPr or SideAV input, you must use theconnection cables to enableconnection. See the illustrationson the left side. | You can useYPbPr to VGA cable (not supplied)to enable YPbPr signal via VGAinput. | You cannot use VGAand YPbPr at the same time.| To enable PC/YPbPr audio,you will need to use the sideaudio inputs with a YPbPr/PC audio cable (not supplied)for audio connection. | If anexternal device is connected viathe SCART socket, the TV willautomatically switch to AV mode.|When receiving DTV channels(Mpeg4 H.264) or while in MediaBrowser mode, output will not beavailable via the scart socket. |When using the wall mountingkit (available from third partyin the market, if not supplied),we recommend that you plug allyour cables into the back of theTV before mounting on the wall.| Insert or remove the CI moduleonly when the TV is SWITCHEDOFF. You should refer to themodule instruction manual fordetails of the settings. | The/EachUSB input of your TV supportsdevices up to 500mA. Connectingdevices that have current valueabove 500mA may damage yourTV. | By connecting an HDMI cableto your TV, you have to use only ashielded HDMI cable to guaranteea sufficient immunity againstparasitic frequency radiation.If you want to connect a device to the TV, make sure that both the TV and the device are turned off before makingany connection. After the connection is done, you can turn on the units and use them.