Panasonic TX-40C320E Operating Instructions Manual

Panasonic TX-40C320E Operating Instructions Manual Manual pdf 25 page image

English - 25 -BroadbandISPconnectionA Wireless-N router (IEEE 802.11a/b/g/n) withsimultaneous 2.4 and 5 GHz bands is designed toincrease bandwidth. These are optimized for smootherand faster HD video streaming, file transfers andwireless gaming.• Use a LAN connection for quicker file sharingbetween other devices like computers.• The frequency and channel differ depending on the area.• The transmission speed differs depending on thedistance and number of obstructions between thetransmission products, the configuration of theseproducts, the radio wave conditions, the line trafficand the products that you use. The transmission mayalso be cut off or may get disconnected dependingon the radio wave conditions, DECT phones or anyother WiFi 11b appliances. The standard values ofthe transmission speed are the theoretical maximumvalues for the wireless standards. They are not theactual speeds of data transmission.• The location where the transmission is most effectivediffers depending on the usage environment.• The Wireless feature of the TV supports 802.11 a,b,g& n type modems. It is highly recommended that youshould use the IEEE 802.11n communication protocolin order to avoid any possible problems while watchingvideos.• You must change your modem’s SSID when there areany other modems around with the same SSID. Youcan encounter connection problems otherwise. Usea wired connection if you experience problems with awireless connection.Configuring Wireless Device SettingsOpen the Network/Internet Settings menu and selectNetwork Type as Wireless Device to start connectionprocess.The TV will scan the wireless networks automatically.A list of available networks will be displayed. Pleaseselect your desired network from the list.Note: If the modem supports N mode, you should set Nmode settings.If the selected network is protected with a password,please enter the correct key by using the virtualkeyboard. You can use this keyboard via the directionalbuttons and the OK button on the remote control.Wait until the IP address is shown on the screen.This means that the connection is now established.To disconnect from a wireless network, highlightNetwork Type and press Left or Right buttons to setas Disabled.Highlight Internet Speed Test and press the OK buttonto check your internet connection speed. HighlightAdvanced Settings and press the OK button to openthe advanced setting menu. Use directional and numericbuttons to set. Press the OK button to save settingswhen complete.Other InformationThe status of the connection will be displayed asConnected or Not Connected and the current IPaddress, if a connection is established.Connecting to your mobile device via WiFi• If your mobile device has WiFi feature, you can connectit to your TV via a router, in order to access the contentin your device. For this, your mobile device must havean appropriate sharing software.• Connect to your router following the steps stated abovein the Wireless Connectivity section.• Afterwards, engage your mobile device with the routerand then activate the sharing software on your mobiledevice. Then, select files that you want to share withyour TV.• If the connection is established correctly, you will beable to access the shared files from your mobile devicevia the Media Player of your TV.• Enter the Media Player menu and the playback deviceselection OSD will be displayed. Select your mobiledevice and press the OK button to continue.• If available, you can download a virtual remotecontroller application from the server of your mobiledevice application provider.Note: This feature may not be supported on all mobiledevices.Connectivity TroubleshootingWireless Network Not Available• Ensure that any firewalls of your network allow theTV wireless connection.• Try searching for wireless networks again, using theNetwork/Internet Settings menu screen.If the wireless network does not function properly, tryusing the wired network in your home. Refer to theWired Connectivity section for more information onthe process.