Panasonic TX-26LXD1 Operating Instructions Manual

Panasonic TX-26LXD1 Operating Instructions Manual Manual pdf 7 page image

7Quick Start GuideProgrammes will appear immediately if your dealer has programmedthe TV for you.If the TV has not been programmed for you then Auto setup will begin.The TV will search for Analogue stations and DVB stations:TV stations will be located, sorted into order and stored ready for use.Stations are sorted into the following order:• DVB Stations: Are sorted by their logical channel number sentby the broadcasters, which cannot be moved or changed.• Analogue Stations: Are sorted into channel order, but can bechanged to your preference. See page 15.The sorted programme order depends upon the TV signal, thebroadcasting system, and reception conditions.21 Connect the mains plug to the wall socket.Press the switch on the TV set to turnthe set on.To switch the TV set to Standby mode, pressthe button on the remote control.The TV set can be switched on by pressingthe button again if it was in Standby mode.Note:This TV will still consume some power evenin the Off mode, as long as the mains plug isstill connected to a live mains socket. IDTVOK1 2 34 5 67 8 9C 0NMODERemote controlsignal sensorCH44EXIT : To exitAUTO SETUP IN PROGRESSSEARCHING : PLEASE WAIT21 68DOWNLOAD IN PROGRESSPLEASE WAITProgramme : 63Remote control unavailablePlease wait ! 21 68This will take about 3 mins.Prog.4647484950Channel4040404040Service NameBBC 5L SportexBBC R5 LiveCBeebiesBBC FourBBC PARLINTNet ID1230212302123021230212302TS ID1638416384163841638416384Quality88888DVB Auto SetupTV to VCR or DVD Recorder DownloadIf a “Q-Link”, “NEXTVIEWLINK” or compatible recording device hasbeen connected to a Scart terminal (AV2 or AV4) before startingStep 1, programme information will be downloaded to that device.3Only the analogue programme positions will be downloaded to the recording device, in the same order asstored in the TV. See page 29.Not all VCRs / DVD Recorders support this download of programme information, some may require to bestarted manually.Refer to the recording device’s operating instruction book.If a recording device other than those described above has been connected, then there will be no download operation.Notes:• If the recording device has not accepted download data from the TV, you may need to select the Downloadoption from the device’s menu system. Refer to the recording device’s operating instruction book.• If Q-Link is not operating correctly, check the following :The Scart cable is connected to the TV’s Scart terminal, AV2 or AV4, and correctly setup in the menu.The Scart cable is connected to the recording device’s compatible (Q-Link, NEXTVIEWLINK or similartechnology) Scart terminal.The Scart cable is a “fully wired” type.• For further information on Q-Link and connecting equipment, see page 29, 43, 46.Power IndicatorStandby : RedOn : No LightDVB IndicatorDVB system active for recordingor DVB tuner lock on : OrangeOtherwise : No Light