18Tuning menu – Manual tuning (Analogue mode only)During Analogue modePress the MENU button.Move to choose Setup menu.Access Setup menu.Move to choose Analogue Tuning Menu.Access Analogue Tuning Menu.Move to choose Manual tuning.Access Manual tuning.Select the programme position to be tuned.Press repeatedly until required station is found.When the desired station is found, press the OK button to store.The programme position will flash.Press the EXIT button at any time to go back to watching TV.It is possible to retune individual programme positions:It is also possible to use the control panel buttons on the front of your TV to tune individual programme positions:Press the F button until Tuning mode is reached.Press the –/ or +/ button to access Tuning mode.Press the TV/AV button to move between Changeprogramme and Search.Press the –/ or +/ button to change programmeposition or start search.When the desired station is found, press the STRbutton to store.The programme position will flash.Repeat above procedure to tune additionalprogramme positions.Press the F button at any time to go back to watchingTV.Note:If your VCR is connected to this TV by an RF cable only, choose programme position “0” to tune to the VCRsignals.Manual tuning (via front panel) (Analogue mode only)CH441Manual tuning (Front panel)21 68- , + : SearchTV / AV : Move cursorSTR : To storeF : To exitSTR F - / + / TV / AVManual tuningReturn ExitStoreSearchdown/upProgrammedown/up21 68CH441MENUEXITOKIDTVOK1 2 34 5 67 8 9C 0NMODE