26OK1 2 34 5 67 8 9C 0NMODEDVB Timer programmingDVB Tuner lockDVB System SetupAV2 outSetup menu AccessOffAV2Q-LinkOffShipping conditionOffNew Service MessageMonitorTVDVB Auto SetupChild lockPower on preferenceOff timerOffMain menuPicture menuSetup menuSound menuDeleteDeleteBBC ONE 20/02--/----/----/----/----/----/----/--12:00--:----:----:----:----:----:----:--12:30--:----:----:----:----:----:----:--30----------------------------Off---------------------Pos. Name1--- ------ ------ ------ ------ ------ ------ ---DateDate 20/02/03Time 12:01Start End min.DVB Timer Programming--/----/----/----/----/----/----/----/----:----:----:----:----:----:----:----:----:----:----:----:----:----:----:----:----------------------------------------------------------Pos. Name--- ------ ------ ------ ------ ------ ------ ------ ---DateDate 20/02/03Time 12:01Start End min.DVB Timer ProgrammingNotes:• To delete a timer programme, select the recording with the cursor bar andpress the Red button.• To edit a previously entered timer programme, select it with the cursor barand press the OK button.• Timer programmes can also be entered from the TV Guide. See page 28.During DVB modePress the MENU button.Move to choose Setup menu.Access Setup menu.Move to choose DVB Timer programming.Access DVB Timer programming.Press the OK button to begin programming.Select the Programme position to be recorded.Move to the Date field.Set the Date on which recording is to take place.DVB Timer programming menuFor an external recording device to record DVB programmes, the integrated DVB system must be active to provide thesignal. The Timer programming menu allows you to choose programmes that you wish to record. At the correct time, theDVB system will switch on and tune to the correct station (even if the TV is in standby mode). If the recording device iscompatible with Q-Link or similar technologies (see page 29) and connected to the TV’s AV2 / AV4 terminal, you do notneed to program the device – the DVB system will control the recording process.The device must be connected to the TV’s AV2 / AV4 terminal using a SCART cable to record DVB programmes.The current Date and Time are shown at the top of the menu.See page 27 for further Date options.Move to the Start time field and set the Start time .Move to the End time field and set the End time .The duration of the recording is shown in the Min. column.The channel position, start and end times can also be inputusing the numeric keys on the remote control.Move to the Subtitles field.If you wish to record subtitles (if available) select Auto.Press the OK button to store.Press the EXIT button to leave the DVB Timer Programming screen.Two minutes before the recording is due to start, a reminder will appear on screen:Notes:Thirty seconds before the recording is due to start the DVB system will tune to the correct station. If you were already watching anotherDVB station you will see the station change on screen. If you were watching an analogue channel, you will not see the change.You can continue to watch analogue stations while a timer recording is in progress.If you attempt to switch to another DVB programme position while a timer recording is in progress the message “DVB prog. is lockedfor recording” will be displayed. Press the OK button to continue recording, or EXIT to unlock the programme position. Beware that ifyou press EXIT, timer programming for this DVB position will be immediately deleted.To immediately cancel a recording that is already in progress, press GUIDE then EXIT.MENUOKOKOKVCR1 2 34 5 67 8 90EXITPress the OK button to remove the reminder from the screen.If you wish to cancel the recording, press the EXIT button.EXITNote:The above 2 operations will not be necessary if the TV set is in standby mode.