Panasonic TX-26LXD1 Operating Instructions Manual

Panasonic TX-26LXD1 Operating Instructions Manual Manual pdf 22 page image

22MENUCommom InterfaceIDTVOK1 2 34 5 67 8 9C 0NMODEEXITOKDVB Timer programmingDVB Tuner lockDVB System SetupAV2 outSetup menuAccessOffAV2Q-LinkOffShipping conditionOffNew Service MessageMonitorTVDVB Auto SetupChild lockPower on preferenceOff timerOffSignal QualityCommon Interface ModulePreferred SubtitlesSettingsDVB System SetupEnglishScreensaver ActiveDefaultAccessDisplay Timeout 3 secondsAfter 2 minutesSystem UpdateFavourites SetupMain menuPicture menuSetup menuSound menuSlot 1: No module insertedCommon Interface AccessSwitch on the TV.During DVB modePress the MENU button.Move to choose Setup menu.Access Setup menu.Move to choose DVB System Setup.Access DVB System Setup.Move to choose Common Interface Module.Access Common Interface Module.Access the module.Common Interface Module menuThe Common Interface Module menu provides access to software contained on Common Interface (CI) Modules.These can be inserted in the “CI” slot located at the rear of the TV.IMPORTANT NOTES:• Switch off the TV using the front panel switch before inserting or removing a module.• If you are installing a TV software update, please follow the dedicated instructions supplied with the module.• Insert / remove a module straightly to the CI slot.Insert the CI module:Some Common Interface Modules may be a two piece design consistingof a card reader together with the viewing card. When using this designof card, first insert the card reader firmly into the CI slot on the TV.Secondly, insert the viewing card into the reader.If no module is inserted the message “No Module Inserted” will bedisplayed.(If you have inserted a module, check that it is fully inserted.)The features that now appear on screen are dependent on the contentsof the selected Common Interface Module.Refer to the instructions supplied with the card or contact the vendor.In all cases, it is possible to navigate the pages using buttons on theremote control, but because the commands available must apply to allmanufacturers of DVB equipment, some on screen commands may notcorrespond exactly to the remote control buttons.For example:For the on screen command ‘select’ or ‘go’, use the OK button.If you see the symbols, use the cursor keys.If you see a line of key words displayed in red, green, yellowand blue, use the coloured buttons to operate the functions.The EXIT button should always allow you to exit the CIsoftware.