Panasonic TH-50PF9EK Operating Instructions Manual

Panasonic TH-50PF9EK Operating Instructions Manual Manual pdf 41 page image

NormalizationWhen both main unit buttons and remote control are disabled due to the “Button lock”, “Remocon User level” or “RemoteID” adjustments, set all the values “Off” so that all the buttons are enabled again.Press the button on main unit together with button on the remote control and hold for more than 5 seconds.The “SHIPPING” menu is displayed and the lock is released when it disappears.2/3OptionsOffOffOffOff0Remote IDSerial IDID selectButton lockRemocon User levelItem Effect AdjustmentsButton lockOff MENU&ENTER OnOff: All the buttons at the bottom of the main unit can be used.MENU & ENTER:Locks MENUand ENTER/buttons on bottom face of main unit.On: Locks all the button on bottom face of main unit.RemoconUser levelOff User1 User2 User3Off: You can use all of the buttons on the remote control.User1: You can only use , , , , , , , buttons on the remotecontrol.User2: You can only use , , buttons on the remote control.User3: Locks all the buttons on remote control.ID selectSets panel ID number when panel is used in “Remote ID” or “Serial ID”.Set value range: 0 - 100(Standard value: 0)Remote ID Off OnOff: Disables ID remote control functions. You can use normal remote control operations.On: Enable ID remote control functions.Serial ID Off OnSets the panel ID Control.Off: Disables external control by the ID.On: Enables the external control by the ID.Item Effect AdjustmentsSlot PowerOff Auto OnOff: Power is not transmitted to the slot power.Auto: Power is transmitted to the slot power only when main power is on.On: Power is transmitted to the slot power when main power is on or in the standby state.Note: In some cases, power is transmitted to the slot power when main power is on or in thestandby state regardless of the slot power setting.V.Installation This mode cannot be used for this model.Rotate Off OnOff: Does not rotate the image.On: Rotates the image 180 degrees.Serial SlotSelectSlot1 Slot2 Slot3Selects the slot which communicates serial.Note: The setting of an external command can be set only from the fixed serial terminal (see page 10).3/3OptionsOffOffOffV. lnstallationRotateSlot1Serial Slot SelectSlot power41Options Adjustments