Panasonic TH-50PF9EK Operating Instructions Manual

Panasonic TH-50PF9EK Operating Instructions Manual Manual pdf 32 page image

32Reduces power consumptionPress to select“Power save”“Standby save”“Power management”“Auto power off”.Press to select “On” or “Off”.On OffPress to exit from Setup.• Power save: When this function is turned On, luminous level of the Plasma Display is suppressed, sopower consumption is reduced.• Standby save: When this function is turned On, power consumption of the microcomputer is reducedduring power supply standby (see page 12, 14-15), so standby power of the set is reduced.• Power management: The unit power supply is turned On or Off depending on whether or not there is a signalduring PC input mode.This function is enabled when it is turned On. (Only during input from PC (Mini D-sub) terminal)• Auto power off: Equipment power supply is turned Off when there is no signal.When this is set to On, the power supply of the unit goes Off 10 minutes after the inputsignals stop.This function is effective for input signals except input from PC (Mini D-sub) terminal.Press to select Input label.Press to change the Input label.Customizing the Input labelsThis function can change the label of the Input signal to be displayed.Select the input signal which you would like to change its label beforecustomizing the Input labels. (see page 13, 15)Note:While selecting an Input signal through Optional Terminal Board connected to Slot1, Slot2 and Slot3, the Input labelwill depend on each Optional Terminal Board.Input labels for Slot1, Slot2, Slot3 and Mini D-sub:[Slot1 Input] INPUT1 / VIDEO1 / COMPONENT1 / RGB1 / DIGITAL1 / PC1 / DVD1 / CATV1 / VCR1 / STB1[Slot2 Input] INPUT2 / VIDEO2 / COMPONENT2 / RGB2 / DIGITAL2 / PC2 / DVD2 / CATV2 / VCR2 / STB2[Slot3 Input] INPUT3 / VIDEO3 / COMPONENT3 / RGB3 / PC3 / DVD3 / CATV3 / VCR3 / STB3[PC (Mini D-sub) input] PC / COMPONENT / RGB / DVD / STBNote:“Power management” and “Auto power off” are effectiveduring normal viewing (one picture screen) only.1/2PCOffStandby save OffPower management OffAuto power off OffOSD Language English (UK)Component/RGB-in selectRGBInput labelSignalPower saveSetup1/2PCOffStandby save OffPower management OffAuto power off OffOSD Language English (UK)Component/RGB-in selectRGBInput labelSignalPower saveSetup123Addition sign “A” “B”Selected Input Composite S VIDEOWhen TY-FB9BD (optional BNC Dual Video Terminal Board) is used, an “A” or “B” is added at the end of each inputlabel, depending on the input selected (see below).