Panasonic TH-50PF9EK Operating Instructions Manual

Panasonic TH-50PF9EK Operating Instructions Manual Manual pdf 40 page image

40Options AdjustmentsItem Effect AdjustmentsInitial VOLlevel Off OnPress button to adjust the volume when TV is turned on.Off OnOff: Sets normal volume.On: Sets your preferred volume.Notes:• When “Maximum VOL level” is “On”, the volume can only be adjusted between 0 and your maximum range.• You can hear the changed volume regardless of your volume setting before opening the options menu ifyou adjust the volume when “Initial VOL level” is “On” and cursor is on the menu.Maximum VOLlevel Off OnPress button to adjust the maximum volume.Off OnOff: Sets auto maximum volume.On: Sets your preferred maximum volume.Notes:• If the “Maximum VOL level” is set lower than the “Initial VOL level”, the “Initial VOL level”automatically becomes the same as the “Maximum VOL level”.• The volume display can go up to 63 regardless of the settings.• You can hear the changed volume regardless of your volume setting before opening the options menu ifyou adjust the volume when “Maximum VOL level” is “On” and cursor is on the menu.INPUT lockOff PC INPUT1 INPUT2 INPUT3Locks the input switch operation.Notes:• Only the adjusted signal is displayed (see page 13).• Signal can be displayed when the Terminal board is installed.• Input switch can be used when this is set to “Off”.• In two screen display mode, if anything other than “Off” is set, the value will be fixed as the valueinput in the single screen display mode.Studio W/B Off OnOff: Nullify all the settings adjusted.On: Sets the colour temperature for TV studio.Note: Valid only when the low is set as colour temperature on screen adjustment.Advanced PIP Off OnOff: Sets normal two screen display mode (see page 21).On: Sets Advanced PIP mode (see page 22).Notes:• When “INPUT lock” is “On”, you cannot use all the two screen display functions.• , buttons are unavailable during Advanced PIP mode operation.Display size Off OnAdjusts the image display size on screen.Off: Sets the normal image display size on screen.On: Sets the image display size approximately 95 % of the normal image display.Off OnNotes:• This setting is valid only when the input signals are as follows; 525i, 525p, 625i, 625p, 750/60p,750/50p, 1125/60i, 1125/50i, 1125/24sF, 1125/25p, 1125/24p, 1125/30p, 1125/50p/60p, 1250/50i(Component Video, RGB, DVI, SDI, HDMI)• This setting is invalid when two screen display, digital zoom or Multi screen is selected.• When “Display size” is set to “On”, “H-Pos” and “V-Pos” in “Pos. /Size” can be adjusted.• Refer to each board's operating instruction for DVI, SDI, HDMI's corresponding signals.1/3OptionsOff-timer functionINPUT lockStudio W/BAdvanced PIPDisplay sizeInitial VOL levelMaximum VOL levelInitial INPUTOnscreen displayOffOffOffOffEnableOnOff0OffOff01/3OptionsOff-timer functionINPUT lockStudio W/BAdvanced PIPDisplay sizeInitial VOL levelMaximum VOL levelInitial INPUTOnscreen displayOffOffOffOffEnableOnOff0OffOff0